Subject: Fw: Laminator power requirements
From: "Michael B" <[email-masked]>
To: <[email-masked]>
Date: Wed, 31 Jul 2013 09:51:53 -0400

Hello Rich.
I thought it might just be easier to forward the email then trying to tell you over the phone.  Let me know if you need anything further.
Thank you,
Michael B
LLPS

From: Jeffery Lorencen 
Sent: Wednesday, July 31, 2013 9:02 AM
To: Michael B 
Subject: Laminator power requirements

Good Morning again,

Following is the email I received from Howard this morning. The spec sheet for the two sided laminating system is attached.  The Laminator requires 230v 30amps with a NEMA 6-30 outlet, the feeder section requires 220v, 9.6A and a NEMA 6-15 outlet and the cutter will require 115v,2A with an NEMA 5-15 outlet. The information is listed on the spec sheet

Attached is the electrical spec for all 3 pieces of equipment. Please assure the install is not going to be in the shipping area but within the building where the temperature and humidity can be controlled. Both the GBC & KIP must be within there specs or we will have issues. Please deliver the specs to MPA and inspect where the equipment will be installed.

Give me a call if you have any questions.

Jeff Lorencen 

Named Account Executive 
Konica Minolta Business Services
Office (517) 679-1108

Cell    (517) 974-3399

[email-masked]
http://kmbs.konicaminolta.us/wps/portal/web/home/home/businesssolutions 
The bitter taste of poor quality remains long after the sweet taste of a low price.